Home › Services › Access Control Placards
The single most overlooked compliance gap on a robotics floor. ANSI R15.06 requires safeguarded entry. OSHA 1910.147 requires the procedure at the point of use. The access control placard is the physical artifact that makes both real. Without one, the cell fails both standards on the same walkthrough.
Why It Matters
Walk a cell with a compliance officer. Within minutes they will look at the gate. If there is no access control placard identifying the cell, the procedure, the energy isolation requirements, and the residual hazards, the citation is essentially automatic. ANSI R15.06 requires safeguarded entry. 1910.147 requires the procedure at the point of use. Without the placard, neither standard is satisfied.
Most facilities did not skip the placard intentionally. The cell was integrated. The integrator handed over a binder. Operations took over. Three years pass. The placard never got built. We see this on roughly half of robot cells we walk during gap analysis.
Materials
Coated aluminum stock used in the most demanding manufacturing environments. Resistant to coolant mist, solvents, oils, UV, and the routine impacts that ruin laminated signage in months.
Color-fast, high-contrast print that holds up to industrial cleaning chemicals and abrasion. Stays legible long after laminated alternatives have faded or peeled.
Permanent industrial adhesive backing rated for the substrates you actually have on your floor. Steel, painted steel, powder coat, fiberglass, and composite gates all covered.
The substrate and coating system are rated for 200-plus years under typical industrial conditions. Replace placards because the cell changed, not because the placard wore out.
FAQ
Durable signage installed at the interlock gated entry point of a robotic cell. It identifies the cell, the authorized procedure for entry, the energy isolation requirements, and any residual hazards. ANSI R15.06 requires safeguarded entry. 1910.147 requires the procedure at the point of use. The placard ties both together physically.
Industrial aluminum with high-color coating and industrial adhesive lasts the life of the cell. Paper, laminate, and printed labels degrade in industrial environments under heat, solvents, coolant mist, and UV. A degraded placard is not point-of-use and stops counting toward 1910.147(c)(4) compliance the moment it becomes illegible.
Yes. Every authorized entry point that is part of the safeguarded perimeter needs an access control placard at that point. ANSI R15.06 treats each entry as its own access protocol. 1910.147 requires the procedure at the point of use, which means each gate.
Placards get updated. We treat placard versioning the same way we treat procedure versioning, both tied to the cell record in LockStep. When tooling, energy sources, or residual hazards change, the placard changes with them. The old placard comes off when the new one goes on.
Free walkthrough to assess what you have, what is missing, and what compliant placards would cost across your floor.
Schedule My Walkthrough